Kit Offers
SALE
CH32pico (CHpico)
Our own CanHobby design using the CH32V003 RISC-V microcontroller.
The Link-E is required to upload firmware.
The internal 8MHz Oscillator works great - crystal is not necessary.
The "Crystal" solder pads may be used as additional GPIOs if the crystal is not installed. (PA1, PA2).
see Related Products to complete a Kit with Link-E and/or 8, 12, 24, 32MHz Crystal.
A +5V / 3V3 jumper selection is provided to enable compatibility with 3V3 or +5V peripherals connected to the GPIOs.
CH32V003 RISC-V microcontroller
SALE
ESP32-C3 (ESP32-C3 WeAct)
ESP32-C3FH4 WeAct
160 MHz single RISC-V core
4Meg Flash + 400K SRAM
13 GPIO + Tx and Rx pins
Upload is via the Built-In USB I/F
USB-C connector for code upload and Power.
WiFi and BlueTooth on-board Antenna
Excellent Arduino IDE Support.
<<< Sample Code >>>
ESP32-C3 WeAct